[evan]

Hi all

I have been searching the web, but haven't found a relatively simple way of wiring up a scissors crossover for DCC (stock rail always the same polarity as outside rail with electrofrog) I am using ground throws and have attached one microswitch to each, but I have the feeling I will need at least 2 microswitches for geting the correct poarity to each part of the crossover..

Any ideas would be appreciated.

Evan

[Simon Varnam]

Try this Link

and read the section on turnouts

http://www.wiringfordcc.com/wirefordcc_toc.htm

[evan]

Hi Simon

Thanks for the link - I looked at that sight and it doesn't cover the more complicated trackwork.

I racked my brain all last night and came up with a solution that only requires one standard microswitch per point (4 in all),

regards

Evan

[evan]

HI again SImon

Oh I've been in Switzerland for too long - my English is failing me..site not sight...